NESS-M1XEP
Part No. 101-215

The NESS-M1XEP is an Ethernet Device Server with a RS-232 Serial Port Interface. It may be used to connect a Control in the M1 Family (M1G or M1EZ8) to an Ethernet network using TCP-IP protocol for programming, remote control and monitoring.

It features a secure embedded web server, with a user interface built on a Java applet, and email event notification. A software setup utility is built into NessRP for configuring the connection setup, network password, etc. The M1XEP is factory defaulted to obtain a dynamic IP address from a DHCP server (i.e. Ethernet switch, cable modem, etc.), however it may also be setup with a static IP address

• Web server with embedded Java applet "M1 Virtual Keypad"
• Secure connection with password protection and HTTPS encryption
• Flash Memory for Firmware Updating
• Event notification via E-Mail (SMTP)
• Internet Monitoring and Reporting Capability
• URL Updating using Dynamic DNS
• TCP/IP stack supporting the following protocols:
  - TCP, UDP, DHCP, SSL 3.0/TLS 1.0, HTTP, SMTP
• Federal Information Processing Standards (FIPS) 128 bit encryption
• Integrated 802.3 compliant 10/100 Mbit network interface
• RS232, DB9M 9-pin serial port connection
• Connects to the M1 RS-232 Serial port (Port 0)
• RJ45 8-pin Network Jack
• 2.1mm barrel type power connector (centre positive)
• LED Indicators for Power, Link, and Data
  

SPECIFICATIONS:

• Operating Voltage: 12 Volts D.C. Power Supply **
• Current Draw: approx. 300 mA
• Housing Dimensions: 4.25" x 6.375" x 2.125"
• Circuit Board Dimensions: 2.25" x 3.95"
  

** Any required network equipment, i.e. Ethernet switch, router, cable modem, etc. including the plug-in power supply for the M1XEP, MUST be backed up with an adequately sized UPS (Uninterruptible Power Supply) in order for the equipment to continue operating during brief power outages.